|
Cutting machine for Heat shrink Tubes & Plastic Sleeves: CTO 13
M/s ‘machine makers r.s.’ have developed and manufactured Cutting machine for Heat shrink tubes as well as other plastic tubes and sleeves. It cuts the sleeves to accurate length and also that too at a very high speed..
The machine uses special guides for different types and sizes of sleeves/tubes. This ensures a good cut. All other setting is completely digital.
This machine is tabletop, user-friendly, and automatic. It is available with Microprocessor controls.
A simple and smart keypad and display is used for setting the length, target quantity, batch qty and other processing parameters.
It comes with in-built production counter, which indicates the number of cuts taken.
The standard machines can cut heat shrink tubes from 3mm dia to 20 mm dia. Round tubes of upto 10 mm diameter can be cut on this machine.
The length can be set from 5mm to 9meters.
Depending upon the length, the machine can process around 3000-12000 pieces per hour. (You may require separate de-reeler to provide free sleeve to machine.)
The machine works on single phase electric supply and 5 bar pneumatic supply.
Special machines for other specific customer needs can also be developed by m/s ‘machine makers r.s.’.
- “MICROPROCESSOR controlled machines with smart display.
- Fully automatic machine. Setting is completely digitized and mostly automatic.
Performance Range
|
Material Types &
Cross section
|
Heat shrink tubes: from 3mm dia to 20 mm dia.
Round tubes: upto 10 mm diameter can be cut on this machine.
Flexible Copper wire : upto 6 sq mm
|
|
Length Selection
|
Standard range: 5 mm to 9 meters, in steps of 1mm;
You may require separate de-reeler to provide free sleeve to machine.
|
|
Accuracy
|
+/- 0.2% (min. +/-1 mm ), Mostly you will get within +/- 0.5 mm
|
|
Multiple Wire Processing
|
Possible with special guide and blades in selective cases
|
|
Changeover setting time
|
30 sec to 5 minutes typically.
|
Technical Data
|
Mechanical system
|
Rugged machine with precision mechanical system
|
|
Electronic system
|
Separate electronic control with PLC and drives
|
|
Tube feed system
|
1 stepping motor with 2 feed rollers, variable speed
|
|
Cutting system
|
Pneumatic Cylinder and Solenoid Valve With Simple centralizing cutter
|
|
Length Measurement system
|
Directly by stepping motor control
|
|
Power
|
220V / 50 Hz, other options upon request
|
|
Compressed air
|
5 to 6 bar, 180 lpm (1.5 hp compressor)
|
|
Dimensions
|
350mm X 350mm X 435mm(h) , approx
|
Production Speed*§:.
|
Length
|
25 mm
|
100 mm
|
500mm
|
1000mm
|
|
Output
|
12000 /Hr
|
5500/Hr
|
3500 /Hr
|
2500/Hr
|
- Speed for 0.5 sq mm multi-strand wires/ 8 mm heat shrink tube
Voltage servo-stabilizer (2KVA) or CVT (1KVA) is must. Proper earthing is essential.
|
